MIL-PRF-2863C(SH)
2.3 Non-Government publications. The following documents form a part of this
document to the extent specified herein. Unless otherwise specified, the
issues of the documents which are DoD adopted are those listed in the issue of
the DoDISS cited in the solicitation. Unless otherwise specified, the issues
of documents not listed in the DoDISS are the issues of the documents cited in
the solicitation (see 6.2).
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
D
512 - Test Methods for Chloride Ion in Water. (DoD adopted)
D
516 - Test Methods for Sulfate Ion in Water.
D
1179 - Test Methods for Fluoride Ion in Water. (DoD adopted)
D
1246 - Test Method for Iodide and Bromide in Water. (DoD adopted)
D
4327 - Test Method for Anions in Water by Ion Chromatography.
(Application for copies should be addressed to the American Society for
Testing and Materials, 100 Barr Harbor Drive, West Conshohocken, PA 19428-
2959.)
2.4 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes
precedence. Nothing in this document, supersedes applicable laws and
regulations unless a specific exemption has been obtained.
3.
REQUIREMENTS
3.1 Qualification. Packing material furnished under this specification shall
be products that are authorized by the qualifying activity for listing on the
applicable qualified products list before contract award (see 4.2 and 6.3).
3.2 Composition. The packing material and construction shall conform to that
of the sample submitted for qualification inspection. Asbestos and
polychlorinated biphenyls (PCBs) shall not be used in the packing material.
The manufacturer shall certify that no asbestos or PCBs were intentionally
included in packing elements, components or coatings.
3.2.1 Recycled, recovered, or environmentally preferable materials.
Recycled, recovered, or environmentally preferable materials should be used to
the maximum extent possible provided that the materials meet or exceed the
operational and maintenance requirements, and promote economically
advantageous life cycle costs.
3.3
Sizes.
3.3.1
Grade A packing.
3.3.1.1 Metallic rings.
Sizes shall conform to those shown in table I, as
specified (see 6.2).
TABLE I.
Sizes for grade A metallic rings
Inside diameter
Outside diameter
Length
(in)
(in)
(in)
0.625
0.781
0.312
0.750
0.906
0.312
0.875
1.031
0.312
1.000
1.156
0.312
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business