A-A-52524/7A
NOTES:
1. Dimensions are in inches. Tolerances are +.002 for seal outside diameters (O.D.) up to and including 2 inches. Tolerances are +0.003, -0.002 for seal O.D. over 2 inches and up to and including 3 inches. Tolerances are +0.004, -0.002 for seal O.D. over 3 inches and up to 7 inches.
2. The part number consists of the CID designator, the CID number, the specification sheet number and 2 dash numbers (see paragraph 6.3 of A-A-52524). The first dash number indicates the size. The second dash number indicates the class. EXAMPLE: A52524/7-11-3 indicates size number 11 with class 3 sealing member.
3. The PIN dash numbers and the former MS part number dash numbers are the same. EXAMPLE: A-A 52524/7-11-3 cross references to MS51911-11-3.
4. The CIDSS is not intended to limit construction to features other than as shown herein by dimensions, notation, or referenced documents.
FIGURE 1. Seal design, construction, and part number - Continued.
3. NOTES. (This section contains information of a general or explanatory nature that may be helpful but is not mandatory.)
3.1 Part or identification number (PIN). The PINs to be used for acquisition of seals are shown in paragraph 6.3 of A-A-52524.
3.2 Cross-reference data. Seals conforming to this CIDSS are interchangeable/substitutable with seals conforming to MS51911C.
MILITARY INTERESTS:
Custodian:
Army – AT
Review Activities:
Army – AR
DLA – IS
CIVIL AGENCY COORDINATING ACTIVITY:
GSA-FSS
Preparing Activity:
Army – AT
(Project 5330-1266)
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business