MIL-PRF-2765E
can be found as enclosure (1) of BUMEDINST 6270.8. The HHA is a review of the gasket material based on
information submitted by the manufacturer, to assess health hazards associated with the handling, application, use
and removal of the product. The gasket material shall not cause any environmental problems during waste disposal
(see 4.7 and 6.5).
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. First article inspection shall consist of the examinations of 4.4 and the tests
specified in 4.5, 4.6 and 4.7.
4.2.1 Sampling for first article inspection. Sufficient first article samples shall be taken from the first
production lot and tested as specified in 4.2.
4.3 Conformance inspection. Conformance inspection shall consist of the examinations of 4.4 and tests
as specified in 4.5.1, 4.5.2, and 4.5.3.
4.3.1 Sampling for quality conformance.
4.3.1.1 Lot. For purposes of sampling, examination and tests, a lot shall consist of not more than 2500
pounds of material of the same form and dimensions, produced in one plant under essentially the same conditions
and offered for delivery at one time. In each case, the number of pieces shall be the lot size.
4.3.1.2 Sampling for examination. For the examination specified in 4.4, representative samples from
different portions of each lot shall be selected as specified in Table IV.
TABLE IV. Sampling for visual and dimensional examination.
Reject 1 2 3
Lot size
Sample size
Accept
1 to 15
all
0
1
16 to 25
15
0
1
26 to 90
25
0
1
91 to 150
35
0
1
151 to 280
40
0
1
281 to 500
50
0
1
501 to 1200
65
0
1
1201 and over
80
0
1
1
All defective items shall be replaced with acceptable items prior to lot acceptance.
2
Inspect sample size until reject criteria is reached. If reject criteria is reached, the entire lot shall be rejected.
3
Reject lots may be screened and resubmitted for inspection and test.
4.3.1.3 Sampling for tests. Four sets of samples shall be taken at random from those selected in 4.3.1.2
in sufficient quantity to conduct the quality conformance tests as specified in 4.5 as applicable. If the items are of
such size or shape that test specimens cannot be prepared from them, substitute samples shall be provided as
molded specimens or in the form of pieces of rubber having dimensions appropriate to the tests required. The
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business