MIL-R-83248C
TABLE VI. suitable size test table
1/8" Spool
cs .070 -011 to -014
1/4" Spool
cs .070 -015 to -021
.103 -113 to -119
.139 -211 to -213
1/2" Spool
cs .070 -022 to -050
.103 -120 to -163
.139 -214 to -258
4.5.2.1 Rejection criteria. A lot shall be rejected upon failure of the samples to meet the test requirements specified in table I or table III when tested in accordance with table VIII or 4.6.5.
4.5.3 Sampling plans B, C, and D. Examination of the end item shall be in accordance with the classification of defects and sample sizes set forth herein. The lot size, for the purpose of determining the sample size, shall be expressed in units of o-rings, molded parts, or yards of sheets, strips, or extruded shapes, as applicable for inspection as specified in 4.5.3.1,
4.5.3.2, and 4.5.3.3. If the end item is less than 1 yard, the sample unit shall be the end item.
4.5.3.1 Sampling plan B - examination for defects in appearance and workmanship. Except where otherwise noted herein, sampling for quality conformance will be in accordance with the specified zero defect sampling plans. One or more defects found in the sample will be cause for rejection of the lot.
4.5.3.1.1 Molded parts including o-rings. The sample unit shall be one molded part and the inspection shall be in accordance with MIL-STD-413 for o-rings and MIL-STD-407 for other molded products. The accept-on-zero sample
size shall be as indicated below:
Lot Size 2 - 8 |
Sample Size entire lot |
9 - 90 |
8 |
91 - 150 |
12 |
151 - 280 |
19 |
281 - 500 |
21 |
501 - 12,000 |
27 |
12,001 - 32,000 |
35 |
32,001 - 100,000 |
38 |
100,001 - 350,000 |
46 |
11
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business