MIL-R-83248C
5.2.1.2 Type I compression seals other than o-rings and type II material. Shipping containers shall contain identical synthetic rubber items of the same shape and size and shall enclose the contents in a snug, tight-fitting manner. The inside height of containers for rubber sheet shall not exceed 10 inches. Rubber strip shall be packaged one roll per container. Containers for extruded rubber shapes shall have an inside maximum cross-sectional area of 36 square inches and, unless otherwise specified by the procuring activity, a maximum length of 10 feet. Unless otherwise specified by the procuring activity, rubber material, other than o-rings shall be packed in wood cleated-plywood shipping containers conforming to PPP-B-601, overseas type. As far as practical, containers shall be uniform in shape and size and contain identical quantities. Container closure and strapping shall be in accordance with the appendix to PPP-B-601. Gross weight of containers shall not exceed 200 pounds.
5.2.2 Level B. Type II materials that have been preserved and packaged as specified in 5.1 shall be packaged in exterior type shipping containers that conforms to PPP-B-636, class weather resistant. The closure of the shipping container shall be in accordance with the appendix of the applicable shipping container specification.
5.2.3 Level C. Type II materials that have been preserved and packaged as specified in 5.1 shall be packed in accordance with the requirements of MIL-STD-2073-1. Fluorocarbon elastomer material preserved and packaged as specified in 5.1.2 shall be packed in a manner which affords adequate protection against damage during direct shipment from the supply source to the first receiving activity for immediate use.
5.2.4 Commercial. Type II materials that have been preserved and packaged as specified in 5.1 shall be packed in accordance with the requirements of ASTM D3951.
5.3 Marking
5.3.1 Level A, B, C. In addition to any special marking or other identification markings required by the contract (see
6.2), each unit pack and exterior container shall be marked in accordance with MIL-STD-129. When applicable, interior packages shall be marked in accordance with 3.6 and as follows:
Rubber (angle, channel, special-shaped section, as applicable) Type , Class ,
Manufacturer's name and address
Compound number
Cross section and length (inches) or part number Solid (molded, extruded, as applicable) Specification MIL-R-83248C
STORE IN A COOL DRY PLACE
5.3.2 Commercial. Type II material shall be marked in accordance with the applicable requirements of ASTM D3951.
5.3.3 Palletization. Unitized loads, commensurate with the level of packing specified in the contract or order shall be palletized in accordance with MIL-STD-147. Palletized loads shall be uniform in size and quantities to the greatest extent possible. If the container is of a size which does not conform to any of the pallet patterns specified in
MIL-STD-147, the pallet pattern shall first be approved by the contracting officer (see 6.2).
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business