MIL-DTL-432H
Rectangular cross section for steel drums (see figure 4).
Type VI - 2 inch bung.
Type VI - .75 inch vent.
Rectangular cross section for filling tube, flexible nozzle cam type
(see figure 5).
Type VII - 1.5 inch ID by 2.5 inch 0D
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in
section 3, 4, or 5 of this standard. This section does not include documents
cited in other sections of this standard or recommended for additional
information or as examples. While every effort has been made to ensure the
completeness of this list, document users are cautioned that they must meet
all specified requirements of documents cited in section 3, 4, or 5 of this
standard, whether or not they are listed.
2.2 Government documents.
2.2.1 Other Government documents, drawings, and publications. The following
other Government documents, drawings, and publications form a part of this
document to the extent specified herein. Unless otherwise specified, the
issues are those cited in the solicitation or contract.
DRAWINGS
U.S. ARMY NATICK SOLDIER CENTER
8-1-161 - Pressure Jig Assembly for Gasket, Nonmetallic
(Copies of these drawings are available from the U.S. Army Natick Soldier
Center, ATTN: AMSRD-NSC-AD-B, Natick, MA 01760.)
2.3 Non-Government publications. The following documents form a part of
this specification to the extent specified herein. Unless otherwise
specified, the issues of these documents are those cited in the solicitation
or contract.
AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM)
D 395
Rubber Property - Compression Set
D 471 Rubber Property - Effect of Liquids
D 1053 Rubber Property - Stiffening at Low Temperatures:
Flexible Polymers and Coated Fabrics
D 1229 Rubber Property - Compression Set at Low Temperatures
D 2240 Rubber Property - Durometer Hardness
(Copies of this document are available from www.astm.org or ASTM
International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA
19428-2959.)
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business