INCH-POUND
MIL-PRF-15624G
15 June 2009
SUPERSEDING
MIL-PRF-15624F
25 May 1994
PERFORMANCE SPECIFICATION
GASKET MATERIAL, RUBBER, 50 DUROMETER HARDNESS (MAXIMUM)
This specification is approved for use by all Departments and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification establishes the requirements for synthetic rubber materials for gaskets 50
durometer hardness (maximum).
1.2 Classification. The synthetic rubber is furnished in the following classes, as specified (see 3.2 and 6.2):
Class I
-
Oil resistant, (chloroprene rubber).
Class II
-
Non-oil resistant, (butadiene-styrene rubber).
Class III
-
Fuel resistant, (butadiene-acrylonitrile rubber).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3, 4, or 5 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements of documents cited in sections 3, 4, or 5 of this
specification, whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-190
-
Identification Marking of Rubber Products
MIL-STD-289
-
Visual Inspection Guide for Rubber Sheet Material
MIL-STD-298
-
Visual Inspection Guide for Rubber Extruded Goods
MIL-STD-407
-
Visual Inspection Guide for Rubber Molded Items
MIL-STD-1916
-
DoD Preferred Methods for Acceptance of Product
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
Comments, suggestions, or questions on this document should be addressed to Commander, Naval Sea Systems
Command, ATTN: SEA 05M2, 1333 Isaac Hull Avenue, SE, Stop 5160, Washington Navy Yard DC 20376-5160
or emailed to CommandStandards@navy.mil, with the subject line "Document Comment". Since contact
information can change, you may want to verify the currency of this address information using the ASSIST Online
database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5330
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business